Treatment:

1. Dry sweeping:

Dry scanning refers to using a relatively short flat brush (reducing the old and the old by 1/3), dipping a small amount of paint slightly lighter than the primary color, painting paper until the color is almost impossible, and then gently repeating the scanning of the appearance model. This can make the "convex" color of the model appearance slightly lighter, with more "convex" feeling, and add a sense of hierarchy.

2. Cleaning:

Washing is one of the commonly used methods for model aging. It means that after the model is painted with the main color and dry, the black grease pigment is diluted with kerosene (thin enough, covered with a small amount of green beans and kerosene mineral water), and then the whole model is "bathed". Its primary purpose is not only to make the appearance older, but also to make the "concave" parts (especially lines) darker in color, look more "concave" and add a sense of hierarchy.

Second, the role of the old therapy

1. Collision damage:

This is a common and slightly ignored scar, because it generally does not cause aggression from the enemy, but is small in area, and is simply ignored). Chongqing Model Company did this old treatment, and gently fell down with nails, and then some metal gray. Although it is wonderful, these details can add interest to the model.

2. War damage:

As a weapon in war, it is inevitable to be injured on the battlefield. Many people make Goddard models and love to make all kinds of battles

A. Non penetrating gun mark:

It is not necessary for the whole Northeast to spend a little time, light mosquito repellent incense (yes, mosquito repellent incense) when using it once, click the surface of the model, get a deeper pit (be careful not to Dian Chuan), and then in the surrounding several pits (intersecting with the main pit), and then make the bullet holes in the overall shape and color black, dry sweep the bullet holes with matte black paint, and reoccupy the boring calx and bullet holes.

B. Bullet hole trace:

In fact, the method of bullet penetration and non penetration is different. In fact, it is not difficult to do it through hatred. Wuhan Model Company only needs to use a small hot screwdriver to gradually rotate through (about 180 degrees) the bullet shaped logo that can be intact, then the bullet trace is black iron, surrounded by matt black photon bullet traces, and then dry the bullet trace with metal ash.

C. Scar formed by sword and electric axe:

This is very simple. Use a heated knife to gently swing from side to side, so that there will be some bulges at both ends. The painting method is the same as the above two methods.

3. Rust:

The anti rust method is very simple. The employees of Wuhan Model Company use the ochre color of oil paint to draw the rust on the surface of the model (if you want to know the wear or water rust of these parts, it is not proposed), and then use a strong absorbent paper towel gently to darken, absorb the solvent (be careful, it is suction, not scrub), so as to rust. It is important to pay attention to the general corrosion condition of some large machines.

4. Paint:

Paint dripping is almost a must for the old style. There are many ways to achieve the effect of paint dripping. Some people take over the paint with gusto, and some people first apply metal primer, then apply the main color, and then stick or scrape the nails with clear adhesive paper. Or use metal gray (colorful) to clean the corners. This method is not as difficult to control as direct craft painting, nor as laborious as color scraping.